Toyota RAV4 (XA50) 2019-2026 Owners Manual: Windshield wipers and washer

Operating the lever operates the wipers or washer as follows:

Intermittent windshield wipers

or *2 Off
*1 or *2 Intermittent operation
*1 or *2 Low speed operation
*1 or *2 High speed operation
*1 or *2 Temporary operation

If equipped, wiper intervals can be adjusted when intermittent operation is selected.

Increases the intermittent windshield wiper frequency
Decreases the intermittent windshield wiper frequency

Pulling the lever operates the wipers and washer.

The wipers will automatically operate a couple of times after the washer squirts.

Rain-sensing windshield wipers

*1 or *2 Off
Rain-sensing operation
*1 or *2 Low speed operation
*1 or *2 High speed operation
*1 or *2 Temporary operation

When "AUTO" is selected, the wipers will operate automatically when the sensor detects falling rain. The system automatically adjusts wiper timing in accordance with rain volume and vehicle speed.

The sensor sensitivity can be adjusted when "AUTO" is selected.

Increases the sensitivity
Decreases the sensitivity

Pulling the lever operates the wipers and washer.

The wipers will automatically operate a couple of times after the washer squirts.

■The windshield wipers and washer can be operated when

The engine switch is in ON.

■Effects of vehicle speed on wiper operation

Vehicles with intermittent windshield wipers

With low speed windshield wiper operation selected, wiper operation will be switched from low speed to intermittent wiper operation when the vehicle is stationary. (However, when the wiper intervals are adjusted to highest level, the mode will not switch.)

Vehicles with rain-sensing windshield wipers

With low speed windshield wiper operation selected, wiper operation will be switched from low speed to intermittent wiper operation when the vehicle is stationary. (However, when the sensor sensitivity is adjusted to the highest level, the mode will not switch.)

■Raindrop sensor (vehicles with rain-sensing windshield wipers)

The raindrop sensor judges the amount of raindrops.

If the wiper switch is turned to the "AUTO" position while the engine switch is in ON, the wipers will operate once to show that "AUTO" mode is activated.
If the wiper sensitivity is adjusted to higher, the wiper may operate once to indicate the change of sensitivity.
If the temperature of the raindrop sensor is 185ºF (85ºC) or higher, or 5ºF (-15ºC) or lower, the automatic operation may not occur. In this case, operate the wipers in any mode other than "AUTO".

■If no windshield washer fluid sprays

Check that the washer nozzles are not blocked if there is washer fluid in the windshield washer fluid reservoir.

WARNING

■Caution regarding the use of windshield wipers in "AUTO" mode (vehicles with rainsensing windshield wipers)

The windshield wipers may operate unexpectedly if the sensor is touched or the windshield is subject to vibration in "AUTO" mode.

Take care that your fingers or anything else does not become caught in the windshield wipers.

■Caution regarding the use of washer fluid

When it is cold, do not use the washer fluid until the windshield becomes warm. The fluid may freeze on the windshield and cause low visibility. This may lead to an accident, resulting in death or serious injury.

NOTICE

■When the washer fluid tank is empty

Do not operate the switch continually as the washer fluid pump may overheat.

■When a nozzle becomes blocked

In this case, contact your Toyota dealer.

Do not try to clear it with a pin or other object. The nozzle will be damaged.

■To prevent battery discharge

Do not leave the wipers on longer than necessary when the engine is off.

Fog light switch

The fog lights offer improved visibility in difficult driving conditions, such as in rain and fog. Operating procedure *1 or *2 Turns the fog lights off Turns the fog lights on *1:For the U.S. .

Rear window wiper and washer

The rear window wiper and washer can be used by operating the lever. NOTICE ■When the rear window is dry Do not use the wiper, as it may damage the rear window. Operating the wiper lever Operating t .

Other materials:

Abs warning light does not come on Wiring diagram Refer to the abs warning light circuit (see page bc-135). Inspection procedure Check can communication system Check if the can communication system dtc is output (see page ca-34). Result Perform active test by intelligent tester (abs warning light) Sele .

How to proceed with troubleshooting Hint: Use these procedures to troubleshoot the supplemental restraint system. *: Use the intelligent tester. Vehicle brought to workshop Inspect battery voltage* Standard voltage: 11 to 14 v If the voltage is below 11 v, recharge or replace the battery before proceeding. .

How to proceed with troubleshooting (2005/11-2006/01) Hint: Use these procedures to troubleshoot the air conditioning system. *: Use the intelligent tester. Vehicle brought to workshop Customer problem analysis and symptom check Inspect battery voltage Standard voltage: 11 to 14 v If the voltage is below 11 v, rechar .

📎📎📎📎📎📎📎📎📎📎